Nameplate Motor 3 Phase

Indicated Above And Is Indicated On The Nameplate.

Nema requires a manufacturer's type, but there is no industry standard for what this is. As load is increased for an operating motor, the shaft and rotor will slow down and the torque will increase to. For example, at 480 v.

When The Motor Is Used At Other Voltages Than The Voltage Indicated On The Nameplate, Its Performance Will Be Affected.

There may be two bearing specifications on a motor nameplate, the drive shaft bearing and the opposite drive shaft bearing. Motor enclosure design totally enclosed. A 10 hp motor could run at 11.5hp.

Typically The Line Current Will Be Less, If The Motor Is Not Fully Loaded.

Motor nameplate specified parameters for the motor such as power factor, efficiency, torque and current are at rated voltage and frequency. The motor’s nameplate maximum amps, not horsepower. The motor has three phases and is for a mains supply with a frequency of 50 hz.

1.3 Rated Output, Rated Voltage, Rated Current The Output Is Shown By The Maximum Shaft Output Power (P) In Kw Or Hp At Which The Motor Can Be Operated Continuously.

This motor, for example, is rated 230/460, meaning it can be wired for operation at either voltage. Your motor nameplate may include bearing information. This represents the number of ac power lines supplying the motor.

This Is Accomplished By Connecting Coils In Series For High Voltage, Or In Parallel For Low Voltage.

With no load on the motor, the current will be much less than the nameplate rating. Code data pada name plate yang kedua, yakni code, ini menunjukkan tipe/model dari motor listrik tersebut. Three phase this is used in industrial shops, rather than peaks and valleys the current supply is more even because of the other two cycles each offset by 120 degrees.